Laser Cutter: Difference between revisions
From Claremont MakerSpace
No edit summary |
No edit summary |
||
| Line 15: | Line 15: | ||
|- | |- | ||
| Polyester Interfacing || Cut || 50 || 100 || 2 || Yes || Burned a bit, and still needed to be torn out (but this did not damage it) -[[User:Adam.goldsmith|Adam.goldsmith]] ([[User talk:Adam.goldsmith|talk]]) | | Polyester Interfacing || Cut || 50 || 100 || 2 || Yes || Burned a bit, and still needed to be torn out (but this did not damage it) -[[User:Adam.goldsmith|Adam.goldsmith]] ([[User talk:Adam.goldsmith|talk]]) | ||
|- | |||
| Polyester Ribbon || Engrave || 15 || 100 || 1 || No || Very brittle, breaks extremely easily -[[User:Adam.goldsmith|Adam.goldsmith]] ([[User talk:Adam.goldsmith|talk]]) | |||
|- | |- | ||
| 80 Lb. Drawing Paper Medium Surface || Cut || 30 || 35 || 1 || No || Burned very slightly on back of paper. -[[User:Don.Fitzpatrick|Don.Fitzpatrick]] ([[User talk:Don.Fitzpatrick|talk]]) | | 80 Lb. Drawing Paper Medium Surface || Cut || 30 || 35 || 1 || No || Burned very slightly on back of paper. -[[User:Don.Fitzpatrick|Don.Fitzpatrick]] ([[User talk:Don.Fitzpatrick|talk]]) | ||
|} | |} | ||
Revision as of 23:45, 5 July 2018
This section has been marked as STUB.
autogenerated, remove when more detail added
| Laser Cutter | |
|---|---|
| Make | GCC LaserPro |
| Model | GLS Hybrid-80Ti |
| Specs | |
| Manual | |
| Requires Certification |
Unknown |
| In Shop | Digital Fab. and Electronics Lab |
Material Settings
| Material Name | Cut/Engrave | Power | Speed | Passes | Air? | Notes |
|---|---|---|---|---|---|---|
| Polyester Interfacing | Cut | 50 | 100 | 2 | Yes | Burned a bit, and still needed to be torn out (but this did not damage it) -Adam.goldsmith (talk) |
| Polyester Ribbon | Engrave | 15 | 100 | 1 | No | Very brittle, breaks extremely easily -Adam.goldsmith (talk) |
| 80 Lb. Drawing Paper Medium Surface | Cut | 30 | 35 | 1 | No | Burned very slightly on back of paper. -Don.Fitzpatrick (talk) |
