Drill Press Certification: Difference between revisions
From Claremont MakerSpace
(Add (most) current certification pages) |
(Increase all header levels in certifications by one) |
||
| Line 1: | Line 1: | ||
{{Certification|version=0.1.0}} | {{Certification|version=0.1.0}} | ||
== Tool Anatomy == | === Tool Anatomy === | ||
* Parts of the drill press are properly identified | * Parts of the drill press are properly identified | ||
| Line 13: | Line 13: | ||
** Table | ** Table | ||
== Pre-Operation == | === Pre-Operation === | ||
* Safety precautions are followed - safety glasses, proper clothing, work area cleared, no gloves etc. | * Safety precautions are followed - safety glasses, proper clothing, work area cleared, no gloves etc. | ||
== Operation == | === Operation === | ||
* Workpiece is clamped to table | * Workpiece is clamped to table | ||
| Line 26: | Line 26: | ||
* Student demonstrates ability to drill a piece of stock with correct technique | * Student demonstrates ability to drill a piece of stock with correct technique | ||
== Post-Operation == | === Post-Operation === | ||
* Work area is cleaned | * Work area is cleaned | ||
== Lockout/Tagout Procedure == | === Lockout/Tagout Procedure === | ||
* Student imparts lockout/tagout procedure: Tool unplugged and plug wrapped in safe/visible location, tag filled out and posted, front desk notified. | * Student imparts lockout/tagout procedure: Tool unplugged and plug wrapped in safe/visible location, tag filled out and posted, front desk notified. | ||
{{CertificationSignOff}} | {{CertificationSignOff}} | ||
Revision as of 16:49, 25 August 2020
| Drill Press Certification | |
|---|---|
| Version | 0.1.0 |
| Approval Date | Draft/NOT APPROVED |
| Prerequisites | |
| Document/Printout | Drill Press Certification |
| Required For Tools/Shops | |
| Student: | |
|---|---|
| Trainer: | |
| Date: | |
| Version: | 0.1.0 - Draft/NOT APPROVED: DO NOT USE |
Certification required for: 5-speed 8 inch bench drill press (Wood Shop), Drill Press (Wood) (Wood Shop)
DO NOT USE THIS PAGE AS A SIGN OFF SHEET
Please print the document from the download link in the top right of the wiki page instead!
Training Check-Off List:
Tool Anatomy
- Parts of the drill press are properly identified
- On/Off switch
- Feed handle
- Depth stop
- Motor
- Column
- Spindle
- Chuck
- Table
Pre-Operation
- Safety precautions are followed - safety glasses, proper clothing, work area cleared, no gloves etc.
Operation
- Workpiece is clamped to table
- Scrap/sacrificial board is placed under workpiece and clamped to table
- Drill bit properly installed in chuck
- Student imparts uses of common bits
- Table is adjusted to proper height and tightened.
- Student demonstrates ability to drill a piece of stock with correct technique
Post-Operation
- Work area is cleaned
Lockout/Tagout Procedure
- Student imparts lockout/tagout procedure: Tool unplugged and plug wrapped in safe/visible location, tag filled out and posted, front desk notified.
| Pass/Fail: |
|---|
| Comments: |
|---|
| Student Signature: | Date | ||
|---|---|---|---|
| Certifier Signature: | Date |
Certifer: Please scan this QR Code to email info@claremontmakerspace.org, and include a list of students who have passed this test.
Then, return this form to the front desk (even if the student failed!).
